• Modular design for up to five (more on request) sensors of any type (PG 13.5 and/or R 1" thread) 

• Cost effective and simple upgrading/backfitting through variable modules
• Enhanced measuring- and process safety through flow monitor module
• Robust against electrical interference through a potential equaliser pin
• Simple assembly (pre-mounted on panel)
• Quick response time of the measurement because of low volume capacity
• Save calibration at the location of the sensor by means of a sampling tap

Multiple Sensor housing for 

• two sensors (pH, redox, conductivitiy, temperatur, fluoride) with thread PG 13.5

plus

• one sensor (chlorine, bromine, chlorine dioxide, ozone) with thread R 1"

• Simple cleaning of the sensor housing and sensor due to a removable housing cup
• Cup can be used as container for a calibration solution
• Enhanced measuring- and process safety as housing is robust against electrical interference due to a potential equaliser pin
• Simple mounting for quick installation
• Quick response time of the measurement because of low volume capacity

• Multiple housing for  four sensors (pH, ORP, conductivitiy, temeperature, fluoride; PG 13.5 thread)

• Simple cleaning of the sensor housing and sensor due to a removable housing cup
• Cup can be used as container for a calibration solution
• Enhanced measuring- and process safety as housing is robust against electrical interference due to a potential equaliser pin
• Simple mounting for quick installation
• Quick response time of the measurement because of low volume capacity

• For up to three electrodes (pH, ORP, conductivity, temperature, fluoride; PG 13.5 thread)
• Immersion depths: 1 m, 2 m

• Fits up to three transmitters beside the electrode(s)
• Simple drawing back of the pipe and modification of the length by the customer due to missing fittings
• Enhanced measuring- and process safety as housing is robust against electrical interference due to a potential equaliser pin
• Simple and quick installation
• High variability due to a lot of accessories
• Assembly to a flange possible

• For one sensor (pH, ORP,  temperature, conductivity; PG 13.5 thread) 
• Mounting: Screw in
• Material: PP for temperatures up to 80°C or stainless steel up to 180°C 
• Thread: R ½" and R ¾"

• Direct and simple assembly in pipes and tanks with enhanced requirements for pressure and temperature

• For one pH or ORP electrode (PG 13.5 thread, length: 110-125mm)
• Mounting: Screw in
• Material: PP
• Thread: 3/4"

• Direct and simple assembly in pipes and tanks
• Exchange of electrodes without interrupting the process